Harley Davidson Exhaust Torque Specs
In this version sold from year 2011 the dry weight is and it is equipped with a V2 four-stroke motor.
Harley davidson exhaust torque specs. With this drive-train the Harley-Davidson Street Glide Special is capable of reaching a maximum top speed of. Ad Fast Free Shipping on Orders Over 40. A listed or recommended torque specification for the same wheel may vary per application and vehicle.
Angle Intake Lift Exhaust Lift Intake Lift TDC Exhaust Lift TDC RPM Low RPM High Min. Install the Torque Cone on a Harley. Harley Davidson Master.
The Harley-Davidson FLHTCUTG Tri Glide Ultra Classic model is a Allround bike manufactured by Harley-Davidson. Type air-cooled Twin Cam 96B Displacement 1584 cm3 Bore X Stroke 37x44 in OR 94 mm Compression Ratio 921 Horsepower 00 KWhpRPM Torque 943000 lb-ftRPM OR 1273000 NmRPM Fuel System. The exhaust flange hex nuts get torqued to 8 to 12 Nm 71 to 106 in lbs but its hard to get a torque wrench in there.
10 - 22 in. This table is based upon Grade 5 fasteners generally used Harley-Davidson motorcycles. The Twin Cam 96 engine replaced the Twin Cam 88 which was produced.
If you are unsure of the proper torque value to use here is a general chart of fastener torque values. I dont have any questions concerning the earlier VRSC rear axles with 24 mm 1516 nuts and torque specs of 95 to 105 ftlbs. To start front jug top 9-18 in lbs then bottom to 100-120 in lbs then back to top tighten to 100-120 in lbs.
Harley-davidson Torque Spec Chart. Agree that purchasing a manual is wise investment. On the topic of chassis characteristics responsible for road holding.