Harley Davidson Exhaust Installation

Do it in your garage or on your patio right on the kickstand.

Harley davidson exhaust installation. Go to AutoZone and rent a frost plug install tool note the curve on the end where the adapter drivers fit. Also make sure that you have the proper springs that are needed when fitting the pieces together as well as the rings that connect from the exhaust to the engine. Install the washer and nut on each cylinder heat stud.

Ive skipped that step and had to take the clip off again. Wipe with a rag and install the new crush gaskets. Install 516 x 18 locking nuts and washers supplied and tighten.

Get more power better performance and better sound. All models require ECM calibration with Screamin Eagle Pro Street Tuner for proper installation. 21 LowRider S Kinda stock.

Remove the oxygen sensors from the stock exhaust using a 916 wrench and install them into the new system if applicable. Recommendations Install stealership. Twist until the clip starts to go over to one side of the pipe then gently slip it off pulling it away from the pipe at the same time.

This is a reliable exhaust system that helps your motor make those nice low rumbling sounds. If you dont have one in ftlbs. That said Im thinking of replacing the OEM exhaust and going with the Gen3 VH Indy exhaust this Spring.

Here is what Im thinking from a cost perspective. Enhanced Performance With the Right Back Pressure. Come join the discussion about modifications troubleshooting maintenance performance classifieds and more.